In the birth of a product, design, tooling, jigs and Assembly methods are in a State of groping, problems are inevitable. Terminals also will encounter many problems in the production process, terminals are common issues in the following categories:

1. size issues: location issue, flatness, GAP value problem;
2. problem: retention problem, plug power, card Board issues;
3. problem: conduction problems, short circuit, contact resistance, and so on.

Below briefly terminal product when there is a problem of the analysis step.

First, more information about issues

By embedding experiment, experimental measurements, do more about issues such as the situation in order to provide a basis for subsequent analysis.

Second, investigate

1, (including plastic parts and metal parts), Assembly, design and the problems related to the analysis of three listed various factors (which may cause).

2, a parts-related factors, but direct measurement of part dimensions, and other ways you can find; and influencing factors related to the Assembly, by measuring the dimensions of finished products, comparative experiments, art, simulation and other methods to find.

Three, and problem-solving strategies

When introducing the problem-solving strategy, a key is changed to consider ease of mould and cost.

Four, project reports (including problem descriptions, causes, and countermeasures of three parts)

After the steps detailed above, to produce first class Terminal products.