Terminals can be any composition of the multi-polar through the wall terminal blocks on each terminal module have barbed locking corrugated terminal shell to prevent finger electric shock design.

Wear a wall terminal blocks with CAGE CLAMP ? unit can be connected 0.08mm2-4mm2 wire per terminal width of 7mm. Terminals can be any composition of the multi-polar through the wall terminal blocks on each terminal module have barbed locking corrugated terminal shell to prevent finger electric shock design. Assembled terminal block without the use of tools can be easily installed in the rectangular mounting hole fixed card sets can be the terminal block tightly locked in the electrical boxes. The terminal block for mounting hole metal wall thickness can be adaptive, adaptive range from 1mm to 4mm. The same shape and the other terminal of the yellow-green ground terminal can automatically grounding connection with the metal tank shell. Terminal on a reliable seal the electrical box IP20 level of dust can make the installation is complete. Diameter of 2mm or 2.3mm test plug can be easily test it.
   
4-channel wear wall PCB terminals with CAGE CLAMP ? unit can be connected to 1.5mm2-than 16mm2 wire, rated current up to 41A. With operating handle, the connection is faster. Installation, the terminals simply inserted from the outside of the mounting plate, put in the internal fixed set, insert the tensioning device can.
   
Wear the wall terminal wires, CAGE CLAMP ? unit in the external wiring side by internal wire plug can flat ends or welding, or using winding technology. 0.08mm2-4mm2 wire suitable for connection, stitch length 6mm. This series of terminals can be easily cards installed in the mounting hole. Use? 2mm test plug for testing.
   
7 terminal blocks can be accessed by the maximum wire cross-sectional area of ??2.5mm2, with auxiliary push buttons and test points, can be installed on the front panel for external wiring. Terminal block with a fixed ear, can be installed in the electrical panel.

Through the wall with a fixed ear terminal blocks with CAGE CLAMP unit, can be soldered to a printed circuit board with the installation in the panel can be flush-mounted, but also highlight the installation can be accessed by the maximum wire cross-sectional area 2.5mm2. Pin spacing of 5mm or 5.08mm terminal block, and a variety of number of poles of terminal blocks you can choose to use.