NewsLocation：Home >> News
How to Replace Electric Stove Parts: Terminal Block
Published：2013-04-28 11:45:06 Views：
"Your butler of connectors" is the concept of Elinker Electric. For all your connector needs we provide worry-free service. We have capabilities from product design to mold development, from parts forming to finished product assembly, and quality control throughout the full range of process. Our service for your needs will be showed everywhere. If it's not the element itself, odds are you need to replace the burner's receptacle. Mine had been loose for so long and shorted out so many times that it was burning away the plastic. Sometimes called a Terminal Block, this part can run you between 15 and 30 dollars, but replacing it is a really easy DIY project.
1,Identify the problem. Check all the electric stove parts. Remove the burner and check for continuity. Do a little research. In my case I could see the little flashes of light as the connection arced inside the receptacle on the stovetop. I was sure the problem with my Kenmore electric stove was where it plugged in. The next time I was at a used appliance store, I bought a terminal block for 15 dollars, including the two ceramic wire nuts.
2,If you're sure you've identified the problem as the burner receptacle and you've gotten the new electric stove parts, you're ready to start. First identify the breaker in your electric panel and cut the power to the stove. If you have the old fuses, remove them. Or you can pull out the stove and unplug it. However you do it, disconnect the appliance from power.
3,Remove the coil burner and the drip bowl below it.
4,Remove the screw that is holding the receptacle on to the range top. Lift up the top of the range until the metal support wire pops into place. Pull the terminal plug away from the stove top.
5,Cut the old receptacle out. I like to cut wires individually. You've disconnected the stove from power, but just in case you made a mistake, there's no reason to tempt fate. If you were to cut both wires at the same time and there was electricity in them you would create a short, and probably blow a hole in your cutters as well as give yourself a nasty jolt - maybe worse.
With the old receptacle removed, strip the wires on the stove top and on the new receptacle if it needs it. I like to fan out the strands of wire so that when they twist together you get a really good connection.
6,Twist together the wire ends and put on the ceramic wire nuts. You want to make sure you're using ceramic ones, not the plastic ones with a metal center, because the heat of the stove top will cause the plastic ones to fail. Reattach the terminal plug to the stove top. Close the top of your stove. Replace the drip bowl and the element.
7,Take one last look at your work. Make sure it all looks clean and in order. Reconnect your stove to power - plug it back in or flip the breaker. Last but not least, give it a test. Hopefully it all works and now makes a safe connection - congratulations on a good little DIY project.
As a connector manufacturer with global strategic planning, we are based in Germany, from Europe to Asia, the Americas, gathering resources used in our global high-quality products and services. We have cooperations with GE, Frisetta, LEIPOLD and other high-quality raw material suppliers to ensure that our raw materials are the first-class. We provide a range of fixed, removable PCB terminal blocks and other wiring products to meet the most needs. To the difficult and special wiring requirements, we would like to offer technical advice and implement the design.