The socket cable connector is a continuous cable bundle, and all sensor terminal block using a dedicated interface, control computer ECU and all parts of the external connections are configured via the connector on the ECU, and signal transfer in the wire harness using the wire connector. It may be argued that, in electric vehicles, control computer ECU central control, wiring harness is a neural network control system, then the wire harness connector is circuit relay stations. However, the connectors in addition to ease of installation, wiring other than accurate, also often fail in use, and the most common failure was poor contact leading to "network" interruption of signal transmission, direct impact on the performance of electric vehicles well normal play.

Wires connectors circuit breaker

Wires connectors circuit breaker failure may be due to breaking of the wire used in the, poor contact between connector and connector Terminal loose making.As the conductor break in the middle of the fault is very rare, mostly in the connector is disconnected, so checks should focus on carefully check the sensor wire and connect Shun Department whether there is loose and poor contact.

Circuit breaker failure caused by poor contact between connector, is often due to the connector end of the rusting, dirt entering the terminals or connections from the outside outlet, resulting in reduced contact pressure. At this point, as long as the connector removed, replace the plug, to change its connection status, make it resume normal contact.