Conventional PCI connector (PCI is an initialism formed from Peripheral Component Interconnect,part of the PCI Local Bus standard and often shortened to PCI) is a computer bus for attaching hardware devices in a computer. These devices can take either the form of an integrated circuit fitted onto the motherboard itself, called a planar device in the PCI specification, or an expansion card that fits into a slot. The PCI connector Local Bus was first implemented in IBM PC compatibles, where it displaced the combination of ISA plus one VESA Local Bus as the bus configuration. It has subsequently been adopted for other computer types. PCI is being replaced by PCI-X and PCI Express, but as of 2011[update], most motherboards are still made with one or more PCI slots, which are sufficient for many uses.

The PCI connector specification covers the physical size of the bus (including the size and spacing of the circuit board edge electrical contacts), electrical characteristics, bus timing, and protocols. The specification can be purchased from the PCI Special Interest Group (PCI-SIG).

Typical PCI cards used in PCs include: network cards, sound cards, modems, extra ports such as USB or serial, TV tuner cards and disk controllers. PCI video cards replaced ISA and VESA cards, until growing bandwidth requirements outgrew the capabilities of PCI; the preferred interface for video cards became AGP, and then PCI Express. PCI video cards remain available for use with old PCs without AGP or PCI Express slots.

Many devices previously provided on PCI connector expansion cards are now commonly integrated onto motherboards or available in universal serial bus and PCI Express versions.

Technical details of Mini PCIMini PCI cards have a 2 W maximum power consumption, which limits the functionality that can be implemented in this form factor. They also are required to support the CLKRUN# PCI signal used to start and stop the PCI clock for power management purposes.

There are three card form factors: Type I, Type II, and Type III cards. The card connector used for each type include: Type I and II use a 100-pin stacking connector, while Type III uses a 124-pin edge connector, i.e. the connector for Types I and II differs from that for Type III, where the connector is on the edge of a card, like with a SO-DIMM. The additional 24 pins provide the extra signals required to route I/O back through the system connector (audio, AC-Link, LAN, phone-line interface). Type II cards have RJ11 and RJ45 mounted connectors. These cards must be located at the edge of the computer or docking station so that the RJ11 connector and RJ45 connector ports can be mounted for external access.