News categories
NewsLocation:Home >> News
Instructions for use of the cable junction box
  Published:2012-05-16 13:52:35   Views:

The cable junction box to use as follows:

According to the cable on the number, diameter select the appropriate junction box.

Floor wiring box can be placed, can also be hung to put fixed in the roadway.

Installation first, unscrew the clamp nut, you can remove the casing.

Wiring when the first unscrew the compression nut or compression splint of the introduction of the device, remove the washer, seals, and sets the appropriate location in the corresponding outer diameter of cable, cable penetration in the lead device.

Strip the cable, and cable access wire points tied to the connection location.

Connection of the cable access terminals on request.

After connecting, tighten the compression nut and compression splint.

Close the casing, Note pad a good ring to tighten the nut.

Elinker expert user warning: in case of power failure, coupling the wiring operation.

After wiring should be noted that the sealed cover and the seat and bell.