Terminal operators in selecting terminal product, often taking into account Terminal sliding problems. Qualified Terminal developers early in the product development will be considering this issue, but there are still many manufacturers due to the lack of resources, outsourcing purchase screws without carefully chosen, leading to product qualified rate is not high, thus missing opportunities for cooperation. Elinker Electric terminals as a professional developer, with strict quality control standards, in each parts of the production process, strict quality control, the aim is to provide customers with the best quality of Terminal products.

Elinker Electric technicians screw slide the following problems be analyzed:

Slip/slide "is threaded connectors, threaded connection due to the excessive force or other causes preventing screw from the occlusal screw wear and threaded connection cannot be tightened. From a physics point of screw "sliding", there are several reasons: first, too much force or partial; the second is excessive wear; the third is poor quality material.

Common solutions in the industry:

1, edge with a hard object on the slide, and then use the appropriate screwdriver unscrew slowly, slowly up the clips should be, that's it!

2, on a daily basis, we will from time to time, access to the screws, such as cycling, fan, hair dryer and other appliances. But if day one long screw (nut) tends to rust, sometimes can't figure out even with a wrench and turn away. What should you do?

(1) earthquake: Rusty] screws, do not hard screw with a wrench to prevent sliding screw unscrew six-sided edges, twist off screw or screw wrench. In this case, hammer lightly shaking handle of the wrench available, rusty screws can be shaken unscrew.

(2) knock: edge with flat top hammer, percussion rusty nuts, it's easy to make nut is loose. For example, bicycle handlebar end retaining nut bolt, according to thickness of the pedal, made of metal, size tap master hard nut. Cast iron nut can be slightly larger, plastic tap. If that doesn't work, then along the circles beat nuts with a hammer, you can easily remove the nut.

(3) burn: some screws stitch Eclipse is very serious, this method still does not work, you can "fight". Screws with a gas welding in oxidizing atmosphere, nut full barbecue and hot screw has a trace of oil drops. Heated screw is intended to enable expansion screws. Drops of oil is intended to enable screws cold shrinking rapidly, increasing the gap between the screw and nut, oil into the nut you can unscrew. But if there are plastic devices use this method with caution.

(4) impact: some of the corrosion of the screws at the top of the device take shape, not using a wrench, pliers for unloading, either by using impact method. First with a hammer and perfectly flat screwdriver at the top screw shock a v-shaped Groove in the vertical direction, then adjusting the Red cone angle, along the direction of screws to rotate out of shock. Stay loose, you can use the wire clamp screw to rotate out. "One" or "cross" slide screw port, this method may be used, combined with the wire clamp screw out.

(5) welding: when removing the device, twist off screw is not uncommon. Off the top of the screw, generally do not use a power drill, because the slightest mistake will drill the hole. Better way is by electric welding welded on a broken wire on a long piece of iron. Iron cross section by the screw diameter. Welding iron prison, quickly to the soldering bit by bit into the oil, nut oil infiltration. After cooling, the small iron Cone back and forth horizontally struck iron at the other end, screws loose, rotate a piece of iron, which can spin out the broken wires.

Elinker Electric has been committed to the high quality of terminal development, our terminal block screws majority required by Elinker Electric production Terminal in using quality is protected.